Question 1 of 30
In a data center environment, a network engineer is troubleshooting a connectivity issue between two switches. The engineer uses the command `show interface status` to check the status of the interfaces. The output indicates that one of the interfaces is in a \"down\" state. What is the most effective next step for the engineer to diagnose the issue further?
Use the command `show logging` to check for any error messages related to the interface.
Immediately replace the cable connected to the interface.
Reboot the switch to reset all interfaces.
Configure the interface with a new IP address to see if it resolves the issue.

Preparing for CISCO 010-151 Supporting Cisco Data Center Networking Devices? Now land the interview.

73% of qualified candidates get rejected because of weak resumes. Build an ATS-optimized, recruiter-ready resume in under 5 minutes - free to start.

Build My Resume Free